Strip and refinish
Floor Cleaning
Strip and refinish, high speed buffing, and carpet care, built on the one job David Beatty has done longer than almost anything else.
Chapter 01
Why a finish fails long before it looks bad
A commercial floor finish rarely fails all at once. It shows up first as traffic lanes worn thin down the middle of a hallway, then as scuffing that won't buff out, then as a powdering film that comes off on a dark shoe, and eventually as a yellowed cast across the whole floor. Most of that comes from the finish being pushed past what it can take: the wrong pad run too aggressively, a dilution that was mixed off, or simply months of foot traffic without a maintenance coat to protect what's underneath. Once a floor gets that far, buffing alone won't bring it back, because the wear has gone through the finish rather than just dulled the top of it.
That's when a strip and refinish is the honest answer. The old finish gets stripped back to the bare floor, the surface gets cleaned and neutralized, and fresh finish goes back on in place of the layers that failed. David Beatty, Clean Sweep Supply's owner, has been doing exactly this kind of floor work for more than thirty years, and it's the specialty he's most known for inside a company that's supplied and serviced Tampa since 1981.
Showroom floor at Clean Sweep Supply in Tampa with buffers, wet vacs and mop equipment on display
High speed buffing is the cheaper habit, if it starts early enough
High speed buffing brings the shine back on a finish that's still intact, and a regular maintenance contract is what keeps a floor in that condition instead of letting it wear down to the point a strip is the only option left. The math is simple even without a price attached to it: a maintenance visit works on a finish that's still there, while a strip and refinish has to rebuild one that's gone. Buildings on a set buffing schedule are, almost without exception, the ones that go years between full strip-outs rather than needing one every season.
Carpet care: when a bonnet clean isn't the answer
Carpet gets the same either-or decision floors do. A bonnet clean, where a spinning pad works detergent across the surface, is fast and fine for light traffic areas that just need refreshing between deeper cleans. It doesn't reach the soil that's worked down into the carpet backing, though, which is where the smell and the graying really live. Extraction, where hot water and cleaning solution get injected into the pile and pulled back out with the dirt, is the call once traffic has built up that deep, or once a bonnet clean stops making a visible difference. Getting that call right, rather than defaulting to whichever is quicker, is part of the same floor-care judgment that goes into deciding a room needs a strip instead of another buff.
Rated 4.9 from 29 Google reviews. Call (813) 726-2449 to talk through what your floors need.